Task: 3D Print a Case for Your Amiga Computer Mouse Adapter Needed: 3D Printer, PLA Filament, STL File for Case Time: 30-60 minutes Introduction I previously posted about purchasing an adapter to connect a PS/2 optical mouse to an Amiga computer. The purchase I made was only for the bare
Read postInstall an Internal BlueSCSI Hard Drive Emulator in a Macintosh LC or Performa Series Retro Computer (10-15 mins)
Task: Install an Internal BlueSCSI Hard Drive Emulator in a Macintosh LC Series Retro Computer Needed: Internal BlueSCSI V2, Mounting Bracket and M6*8 Screws, SCSI Ribbon Cable Time: 10-15 minutes Introduction I have previously posted about the amazing BlueSCSI version 2 device that uses a RaspberryPi Pico to emulate a
Read post3D Print a New Bottom Trapdoor to Ventilate the PiStorm32 Lite on Your Amiga 1200 (30-60 mins)
Task: 3D Print a New Bottom Trapdoor to Ventilate the PiStorm32 Lite on Your Amiga 1200 Needed: STL file, 3D printer Time: 30-60 mins Disclosure: Note that as an eBay Partner Network Affiliate, I may earn from qualifying purchases Introduction I previously posted about installing a PiStorm32 Lite on an
Read postMake an Amiga 1200 Computer Back Trapdoor Using a 3D Printer (15-30 mins)
Task: Make Amiga Computer Case Parts Using a 3D Printer Needed: 3D Printer, Filament, STL File or Design Time: 15-60 minutes Disclosure: Note that as an eBay Partner Network Affiliate, I may earn from qualifying purchases Introduction I recently posted about my Amiga a1200 NG build that featured a newly
Read postBuild a 2-in-1 Dead and Diagnostic Test Cartridge for Diagnosing Non-Working Commodore 64s (1-2 hrs)
Task: Build a 2-in-1 Dead and Diagnostic Test Cartridge for Diagnosing Non-Working Commodore 64s Needed: 2-in-1 circuit board, two EEPROM chips, an EEPROM programmer, two 100 nF capacitors, soldering iron, cartridge case and screw(s) Time: 1-2 hours Disclosure: Note that as an eBay Partner Network Affiliate, I may earn from
Read postPurchase a 3D Printer for Designing and Printing Parts for Retro Computers (30-60 mins)
Task: Purchase a 3D Printer for Designing and Printing Parts for Retro Computers Needed: 3D Printer Time: 30-60 minutes Disclosure: Note that as an eBay Partner Network Affiliate, I may earn from qualifying purchases. Introduction Over the last several years I have found myself purchasing more and more 3D-printed parts
Read post